PE4307
Abstract: PE4307-EK peregrine QFN footprint 4307 20 pin QFN
Text: ADVANCE INFORMATION PE4307 RF Digital Attenuator 5-bit, 15.5 dB, DC – 2.0 GHz Product Description Features • Attenuation: 0.5 dB steps to 15.5 dB • Flexible parallel and serial programming interfaces • Unique power-up state selection • Positive CMOS control logic
|
Original
|
PE4307
PE430x
PE4307
75-ohm
PE4307-EK
peregrine
QFN footprint
4307 20 pin QFN
|
PDF
|
Untitled
Abstract: No abstract text available
Text: Product Specification PE4307 75 Ω RF Digital Attenuator 5-bit, 15.5 dB, DC – 2.0 GHz Product Description Features • Attenuation: 0.5 dB steps to 15.5 dB • Flexible parallel and serial programming interfaces • Latched or direct mode • Unique power-up state selection
|
Original
|
PE4307
PE430x
PE4307
|
PDF
|
PE4307
Abstract: PE4307-EK 20 pins qfn 4x4 footprint
Text: Product Specification PE4307 75 Ω RF Digital Attenuator 5-bit, 15.5 dB, DC – 2.0 GHz Product Description Features • Attenuation: 0.5 dB steps to 15.5 dB • Flexible parallel and serial programming interfaces • Latched or direct mode • Unique power-up state selection
|
Original
|
PE4307
PE430x
PE4307
75ohm
PE4307-EK
20 pins qfn 4x4 footprint
|
PDF
|
Untitled
Abstract: No abstract text available
Text: Product Specification PE4307 75 Ω RF Digital Attenuator 5-bit, 15.5 dB, DC – 2.0 GHz Product Description Features • Attenuation: 0.5 dB steps to 15.5 dB • Flexible parallel and serial programming interfaces • Latched or direct mode • Unique power-up state selection
|
Original
|
PE4307
PE430x
PE4307
|
PDF
|
Untitled
Abstract: No abstract text available
Text: Product Specification PE4307 75 Ω RF Digital Attenuator 5-bit, 15.5 dB, DC – 2.0 GHz Product Description The PE4307 is a high linearity, 5-bit RF Digital Step Attenuator DSA covering a 15.5 dB attenuation range in 0.5 dB steps. The device is pin compatible with the PE430x series. This 75ohm RF DSA provides both parallel (latched or direct mode)
|
Original
|
PE4307
PE4307
PE430x
75ohm
|
PDF
|
Untitled
Abstract: No abstract text available
Text: BNC Male Right Angle Connector Clamp/Solder Attachment For RG174, RG316, RG188 TECHNICAL DATA SHEET PE4307 BNC Male Right Angle Connector Clamp/Solder Attachment For RG174, RG316, RG188 Configuration Connector Connector Interface Type Cable Attachment Method Shield/Contact
|
Original
|
RG174,
RG316,
RG188
PE4307
RG174
RG316
|
PDF
|
Untitled
Abstract: No abstract text available
Text: Product Specification PE4307 75Ω RF Digital Attenuator 5-bit, 15.5 dB, 1 – 2000 MHz Product Description Features • Attenuation: 0.5 dB steps to 15.5 dB Flexible parallel and serial programming interfaces Latched or direct mode Unique power-up state selection
|
Original
|
PE4307
PE430x
20-lead
PE4307
|
PDF
|
Untitled
Abstract: No abstract text available
Text: Product Specification PE4307 75Ω RF Digital Attenuator 5-bit, 15.5 dB, DC – 2.0 GHz Product Description The PE4307 is a high linearity, 5-bit RF Digital Step Attenuator DSA covering a 15.5 dB attenuation range in 0.5 dB steps. The device is pin compatible with the
|
Original
|
PE4307
PE4307
PE430x
75-ohm
|
PDF
|
Untitled
Abstract: No abstract text available
Text: Product Specification PE4307 75 Ω RF Digital Attenuator 5-bit, 15.5 dB, DC – 2.0 GHz Product Description The PE4307 is a high linearity, 5-bit RF Digital Step Attenuator DSA covering a 15.5 dB attenuation range in 0.5 dB steps. The device is pin compatible with the PE430x series. This 75ohm RF DSA provides both parallel (latched or direct mode)
|
Original
|
PE4307
PE4307
PE430x
75ohm
|
PDF
|
20 pins qfn 4x4 footprint
Abstract: No abstract text available
Text: Product Specification PE4307 75Ω RF Digital Attenuator 5-bit, 15.5 dB, 1 – 2000 MHz Product Description Features • Attenuation: 0.5 dB steps to 15.5 dB Flexible parallel and serial programming interfaces Latched or direct mode Unique power-up state selection
|
Original
|
PE4307
PE4307
PE430x
75-ohm
20 pins qfn 4x4 footprint
|
PDF
|
qualcomm 7500
Abstract: rf spdt mhz dbm 32 pins qfn 5x5 footprint E k m QFN 3X3 F QFN 3X3 PE42692 QUALCOMM Reference design QUALCOMM QFN GSM qualcomm PE3336
Text: 2008 Product Selection Guide Changing how you design RF. Forever. Welcome to Peregrine Semiconductor UltraCMOS RF Process Technology Peregrine Semiconductor is a leading supplier of high-performance RF CMOS and mixed-signal communications ICs which are ideally suited for
|
Original
|
10B-6
qualcomm 7500
rf spdt mhz dbm
32 pins qfn 5x5 footprint
E k m QFN 3X3
F QFN 3X3
PE42692
QUALCOMM Reference design
QUALCOMM QFN
GSM qualcomm
PE3336
|
PDF
|
dsas 5-0
Abstract: PE4304 pe4259 AN27 PE4210 PE4230 PE4237 PE4239 PE4242 PE4244
Text: Application Note AN27 9380 Carroll Park Drive • San Diego, CA 92121, USA Tel: 858-731-9400 • Fax: 858-731-9499 858 • www.psemi.com Using Blocking Capacitors with UltraCMOSTM Devices Introduction Peregrine’s UltraCMOSTM switches and DSAs have many advantages over other technologies.
|
Original
|
|
PDF
|
PE43701
Abstract: Digital Step Attenuators
Text: Digital Step Attenuators April 2009 PE43xxx Monolithic RF UltraCMOS Digital Step Attenuators TM New PE43x0x series provides versatile HaRP -enhanced 5, 6 and 7-bit DSAs with high linearity TM The PE43xxx family of Digital Step Attenuators DSAs features unprecedented levels of broadband linearity,
|
Original
|
PE43xxx
PE43x0x
linea73
10B-6
PE43701
Digital Step Attenuators
|
PDF
|
Application Note AN26
Abstract: PE43701 pe43702 si1920 PE4302 PE4305 PE4306 PE4307 PE4308 720045
Text: Application Note AN26 9380 Carroll Park Drive • San Diego, CA 92121, USA Tel: 858-731-9400 • Fax: 858-731-9499 • www.psemi.com Advantages of UltraCMOS DSAs with Serial-Addressability Introduction Today’s RF systems are more complex than ever as designers seek to integrate more functionality
|
Original
|
|
PDF
|
|
|
PE33632
Abstract: PE33362 PE33632 die pe33382 PE42692 PE33362 die PE42510A1 PE4340 PE33631 PE42694
Text: 2010 Product Selection Guide First Changing how you design RF. Forever. Edition Welcome to Peregrine Semiconductor UltraCMOS : The Green RF Process Technology Peregrine Semiconductor is a leading supplier of high-performance RF CMOS and mixed-signal communications ICs which are ideally suited for
|
Original
|
and940
10B-6
PE33632
PE33362
PE33632 die
pe33382
PE42692
PE33362 die
PE42510A1
PE4340
PE33631
PE42694
|
PDF
|
CBJE130-1
Abstract: XICON Capacitor SMD EK 742 DigiKey Electronics Catalog sip10 "resistor array" mouser 10k ohm 16 pin dip resistor network smd diode MARKING D8 SMA SMD Capacitor symbols smd code RN4
Text: 5 4 GND C1 6 18 GND C0_5 5 17 NC LE 4 16 NC DATA 3 15 NC CLK 2 14 NC NC 1 3 2 1 CA3 100pF 2 3 4 5 3 2 1 C16 C8 C4 C2 C1 C0_5 PS LE RN2 220 10 9 8 7 1 2 3 4 5 6 7 8 J8 CON3 16 15 14 13 12 11 10 9 1 2 3 4 5 6 7 8 RN3 470 16 15 14 13 12 11 10 9 1 2 3 4 5 6 7
|
Original
|
100pF
106-1208-EV
J502-ND
S2021-36-ND
20Data/741-746
20Series
com/pdf/4600X
20Components/Web
20Data/142-0701-801,
CBJE130-1
XICON Capacitor
SMD EK 742
DigiKey Electronics Catalog
sip10 "resistor array"
mouser
10k ohm 16 pin dip resistor network
smd diode MARKING D8 SMA
SMD Capacitor symbols
smd code RN4
|
PDF
|
PE43x0x
Abstract: PE43503 pe43702 QFN-32L 5X5 PE4304 PE4302 PE4305 PE4306 PE4309 PE43204
Text: Digital Step Attenuators May 2010 PE43xxx Monolithic RF UltraCMOS Digital Step Attenuators TM PE43x0x series provides versatile HaRP -enhanced 2, 4, 5, 6 and 7-bit DSAs with high linearity TM The PE43x0x family of Digital Step Attenuators DSAs features unprecedented levels of broadband linearity,
|
Original
|
PE43xxx
PE43x0x
Tower10B-6
PE43503
pe43702
QFN-32L 5X5
PE4304
PE4302
PE4305
PE4306
PE4309
PE43204
|
PDF
|
TAG 302-600
Abstract: PE42924
Text: Changing RF Design. Forever. TM 2013 Commercial Products Product Selection Guide First Edition Welcome to Peregrine Semiconductor UltraCMOS RF Process Technology Peregrine Semiconductor NASDAQ: PSMI is a fabless provider of high-performance radio-frequency (RF)
|
Original
|
|
PDF
|
Untitled
Abstract: No abstract text available
Text: Digital Step Attenuators January 2006 PE430x Monolithic RF UltraCMOSTM Digital Step Attenuators IP3 >50 dBm maintained from 1 MHz to 2.5 GHz The PE430x family of Digital Step Attenuators DSAs features unprecedented levels of broadband linearity, attenuation
|
Original
|
PE430x
|
PDF
|
PE42692
Abstract: F QFN 3X3 PE42xx SPDT stacked FET PE42552 03 07 qfn 3x3 flip flap PE3336 PE3341 PE4230
Text: 2009 Product Selection Guide First Changing how you design RF. Forever. Edition Welcome to Peregrine Semiconductor UltraCMOS RF Process Technology Peregrine Semiconductor is a leading supplier of high-performance RF CMOS and mixed-signal communications ICs which are ideally suited for
|
Original
|
high-re3940
10B-6
PE42692
F QFN 3X3
PE42xx
SPDT stacked FET
PE42552
03 07 qfn 3x3
flip flap
PE3336
PE3341
PE4230
|
PDF
|
PE4303
Abstract: AN33 PE4302 PE4305 PE4306 PE4307 PE4308
Text: 040311 AN33: Application Note Summary Peregrine Semiconductor Application Note AN33 demonstrates socket and software compatibility of the 5 bit and 6 bit digital step attenuators products. This family offers high performance attenuation accuracy and linearity using only a single 3 volt
|
Original
|
|
PDF
|
PE42480
Abstract: No abstract text available
Text: 2014-2015 High-Performance Analog Product Catalog Welcome to Peregrine Semiconductor Peregrine Semiconductor NASDAQ: PSMI , founder of RF SOI (silicon on insulator), is a leading fabless provider of high-performance, integrated RF solutions. Since 1988 Peregrine and its founding
|
Original
|
DOC-35227-4
PE42480
|
PDF
|
PE4308
Abstract: PE4304 PE4302 PE4305 PE4306 PE4307
Text: NEWS RELEASE EDITORIAL CONTACT: Rodd Novak, Director of Marketing 858 731-2864 Reader/Literature Inquiries: Richardson Electronics 1-800-737-6937 Cindy Trotto, PR/MarCom (602) 750-7203 FOR IMMEDIATE RELEASE Peregrine Semiconductor extends portfolio with
|
Original
|
75-Ohm
PE4305,
PE4306,
PE4307
PE4308
PE4304
PE4302
PE4305
PE4306
|
PDF
|
PE4307
Abstract: No abstract text available
Text: BODY CONTACT INSULATOR MATERIALS BRASS NICKEL PLATED SILVER PLATED PTFE ASSEMBLY PROCEDURES 1. SLIDE CLAMP NUT 1 , WASHER ( 2 ) & GASKET (3 ) OVER CABLE. STRIP CABLE AS SHOWN. DO NOT NICK BRAID WHILE CUTTING JACKET. TAPER END OF BRAID TO PERMIT ASSEMBLY OF BRAID CU\MP (4 ). SLIDE BRAID CLAMP (4 ) OVER BRAID <Sc
|
OCR Scan
|
rg174,
rg188
rg316
PE4307
PE4307
|
PDF
|
