Contextual Info: Application Note VS-702 VCSO Typical Phase Noise and Jitter Measurements Phase Noise Results Phase noise measurements were performed on an Agilent E5052 SSA using an evaluation board with AC coupled output. The E5052 SSA has a phase noise to jitter integration calculation feature and devices

VDUGLD-51M840

Abstract: E5052A 19M440 24M704
Contextual Info: Application Note V-Type, CMOS VCXO Typical Phase Noise Measurements Phase Noise Results Phase noise measurements were performed on an Agilent E5052A signal source analyzer SSA . The E5052A has a phase noise to jitter integration calculation feature and devices were characterized in the

vectron

Abstract: E5052A VTC4-B22E-12M800 vtc4
Contextual Info: Application Note VTC4, Clipped Sine Wave TCXO Typical Phase Noise Measurements Phase Noise Results Phase noise measurements were performed on an Agilent E5052A signal source analyzer SSA . The E5052A has a phase noise to jitter integration calculation feature and devices were characterized in the

E5052B

Abstract: 11970W E5001A E5053A E5052B-011 11970A Average Current Mode Controlled Power Factor Corr 1 watt RF band pass filter 2.45 ghz N5507 11970U
Contextual Info: Agilent E5052B Signal Source Analyzer 10 MHz to 7 GHz, 26.5 GHz, or 110 GHz Data Sheet Definitions RF Input Port All specifications apply over a 23 °C ± 5 °C range unless otherwise stated and 30 minutes after the instrument has been turned on. Table 1-1. RF IN port

Agilent E5052 settling time

Abstract: E5052A E5001A 801 floppy n5507a E5053A E5052A-011 N5507
Contextual Info: Agilent E5052A Signal Source Analyzer 10 MHz to 7, 26.5, or 110 GHz Data Sheet Definitions All specifications apply over a 18 °C to 28 °C range unless otherwise stated and 30 minutes after the instrument has been turned on. All specified and supplemental values for RF input signals are

FSUP26

Contextual Info: reference phase locked translator connectorized MODEL: KFcts800-10 800 MHz fixed frequency FEATURES: ► Ultra-Low Phase Noise ► No Programming Required Phase Noise Measured with Agilent E5052A or R&S FSUP-26/27 -60 -70 Phase Noise (dBc/Hz) -80 -90 -100

E5052A

Abstract: 3 phase soft start Z-Communications IS-136 AN-109 fixture
Contextual Info: VCO Application Note AN-109 Phase Noise Measurement of Z-Communications VCOs Phase noise of ZCOMM VCOs free running can be measured at different offsets, using the test set up and procedure below. Figure AN-109:1- VCO Phase Noise Measurement Setup Procedure using Agilent Technologies E5052A Signal Source Analyzer

FCTS1000-10

Contextual Info: reference phase locked translator surface mount MODEL: Fcts800-10 800 MHz fixed frequency FEATURES: ► Ultra-Low Phase Noise ► No Programming Required Phase Noise Measured with Agilent E5052A or R&S FSUP-26/27 -60 -70 Phase Noise (dBc/Hz) -80 -90 -100

C0413

Abstract: FSUP26 FCTS1000-10
Contextual Info: reference phase locked translator connectorized MODEL: KFcts1000-10 1000 MHz fixed frequency FEATURES: ► Ultra-Low Phase Noise ► No Programming Required Phase Noise Measured with Agilent E5052A or R&S FSUP-26/27 -70 -80 Phase Noise (dBc/Hz) -90 -100

FCTS1000-10

Contextual Info: reference phase locked translator surface mount MODEL: Fcts1000-10 1000 MHz fixed frequency FEATURES: ► Ultra-Low Phase Noise ► No Programming Required Phase Noise Measured with Agilent E5052A or R&S FSUP-26/27 -70 -80 Phase Noise (dBc/Hz) -90 -100

Contextual Info: Agilent E5052B Signal Source Analyzer 10 MHz to 7 GHz, 26.5 GHz, or 110 GHz Data Sheet Definitions RF Input Port All specifications apply over a 23 °C ± 5 °C range unless otherwise stated and 30 minutes after the instrument has been turned on. Table 1-1. RF IN port

VC-800-LAF-GTJ-19M440

Abstract: VCXO vectron E5052A VC-800 27M000 VC-800-LAF-GTJ-32M768 VECTRON
Contextual Info: Application Note VC-800, CMOS VCXO Typical Phase Noise Measurements Phase Noise Results Phase noise measurements were performed on an Agilent E5052A signal source analyzer SSA . The E5052A has a phase noise to jitter integration calculation feature and devices were characterized in the

VCC6-QAB-156M25

Abstract: VCC6-QCD-250M000 Vectron International E5052A vectron VCC6-QAB-155M52 VCC6-QCB-87M500 Noise VCC6-QAB-74M250 VCC6-QCD-250M00
Contextual Info: Application Note VCC6, LVPECL XO Typical Phase Noise Measurements Phase Noise Results Phase noise measurements were performed on an Agilent E5052A signal source analyzer SSA . The E5052A has a phase noise to jitter integration calculation feature and devices were characterized in the

NB6N11SMNG

Contextual Info: NB6N11S 3.3 V 1:2 AnyLevelE Input to LVDS Fanout Buffer / Translator Description The NB6N11S is a differential 1:2 Clock or Data Receiver and will accept AnyLevel input signals: LVPECL, CML, LVCMOS, LVTTL, or LVDS. These signals will be translated to LVDS and two identical

ADF4350

Abstract: ADF4351 ADF4350BCPZ ADF4350BCPZ-RL7 SW 5189 C EVAL-ADF4350EB2Z ADSP-BF527 DB31 E5052A GSM900
Contextual Info: Wideband Synthesizer with Integrated VCO ADF4350 FEATURES GENERAL DESCRIPTION Output frequency range: 137.5 MHz to 4400 MHz Fractional-N synthesizer and integer-N synthesizer Low phase noise VCO Programmable divide-by-1/-2/-4/-8/-16 output Typical rms jitter: <0.4 ps rms

CF5076

Abstract: WF5076
Contextual Info: 5076 series VCXO Module IC with Built-in Varicap OVERVIEW The 5076 series are miniature VCXO ICs that provide a wide frequency pulling range, even when using miniature crystal units for which a wide pulling range is difficult to provide. They employ a recently developed varicap diode fabrication process that provides a wide frequency pulling range and good linearity without any

Contextual Info: LMK03200 Precision Clock Conditioner with Integrated VCO Evaluation Board Operating Instructions 6-16-2009 National Semiconductor Corporation Interface 2900 Semiconductor Dr. MS A2-600 Santa Clara, CA, 95052-8090 L M K 0 3 2 0 0 E V A L U A T I O N B O A R D

Contextual Info: LMX2531LQ1570E Evaluation Board Operating Instructions National Semiconductor Corporation Wireless Communications, RF Products Group 2900 Semiconductor Dr. M/S A-600 Santa Clara, CA, 95052-8090 LMX2531LQ1570EFPEB Rev 1.20.2006 L M X 2 5 3 1 L Q 1 5 7 0 E E V A L U A T I O N

CDCM7005HFG-V

Abstract: smd y1a
Contextual Info: CDCM7005-SP www.ti.com . SGLS390A – JULY 2009 – REVISED AUGUST 2009 3.3-V HIGH PERFORMANCE RAD-TOLERANT CLASS V, CLOCK SYNCHRONIZER AND

Contextual Info: VCC6 LVPECL, LVDS Crystal Oscillator Data Sheet VCC6 Description Vectron’s VCC6 Crystal Oscillator is a quartz stabilized, differential output oscillator, operating off either a 2.5 or 3.3 volt supply, hermetically sealed 5x7 ceramic package. Features Applications

Contextual Info: VV-701 Voltage Controlled Crystal Oscillator Previous Vectron Model VVC1/VVC2 VV-701 Description Vectron’s VV-701 Voltage Controlled Crystal Oscillator VCXO is a quartz stabilized square wave generator with a CMOS output. The VV-701 uses fundamental crystals resulting in low jitter performance and a monolithic IC which improves reliability and reduces cost.

E4445A

Abstract: 3102006 933MHZ C100 C101 C103 C104 C105 E5052 LMX2531LQ1742
Contextual Info: LMX2531LQ1742 Evaluation Board Operating Instructions National Semiconductor Corporation Wireless Communications, RF Products Group 2900 Semiconductor Dr. MS A2-600 Santa Clara, CA, 95052-8090 LMX2531LQ1742FPEB Rev 3.10.2006 L M X 2 5 3 1 L Q 1 7 4 2 E V A L U A T I O N

OX36D-S-MR-R

Abstract: dox5 18M08 transistor z7m st z7m Bowei Integrated Circuits oxln50d TXM11 tt 2246 transistor K117
Contextual Info: ABOWEI n r r y /^ B i i ij Products BOWEI IN TEG RA TED C IR C U IT S C O .,LTD 2 0 0 7 .5 A bow ei BOWEI is one ofthe leading RF/microwave solution providers in China. With more than twenty years extensive experience, BOWEI has been engineering and manufacturing

Contextual Info: VT-841 Temperature Compensated Crystal Oscillator VT-841 Description Vectron’s VT-841 Temperature Compensated Crystal Oscillator TCXO is a quartz stabilized, clipped sine wave output, analog temperature compensated oscillator, operating off a 1.8, 2.5, 2.8, 3.0, 3.3 volt supply in a hermetically sealed 2.5x2.0mm 4-pad